InstallForge Community

Hello Community,

How do I register DLL after install?

Tried the load DLL in Finish page but it doesn't work.


Thanks in advance

You can write a batch file as mentioned below

regsvr32 path to dll file
and then mention it in the commands section of the setup option. It should work

Wow!
Over 12,000 views
Maybe there's a function missing
Its not mentioned in help file either
Good reason not to donate
They missed it in options - should be a "Register DLL and OCXs"
And have not even put it in the help file
20 Euros from me I keep

RickBis99,

the answer to that question was posted by vinayakm. It is special task which is the reason why it is not explained in the InstallForge documentation.

Hello,
To register a DLL Dynamic Link Library file after installation, you can use the regsvr32 command in Command Prompt. Open Command Prompt as Administrator, then type regsvr32 path\to\your.dll and press Enter. This command adds the DLL to the Windows Registry, sso id making it available for use by applications. Make sure the DLL is compatible with your system (32-bit vs. 64-bit) and that all dependencies are present. This step is often needed when installing custom components or third-party software libraries manually.